Abstract:SiO2 and ZrO2 were added to powder metallurgy Cu-based friction materials respectively. The effects of SiO2 and ZrO2 on the friction and wear properties of powder metallurgy Cu-based friction materials mated with C/C-SiC composites were studied, and the internal relationship between their influence mechanisms was analyzed. The results show that the Cu-based friction materials containing SiO2 or ZrO2 can achieve high average friction coefficient (0.375 8 and 0.342 4 respectively) at high braking speeds when they is mated with C/C-SiC composites. The wear of the friction materials are very low, which is 1.44 μm/time and 0.95 μm/time respectively, and the C/C-SiC composites has almost no wear. During the braking process, SiO2 is easy to fall off and form abrasive particles, causing abrasive wear on the two friction surfaces. However, ZrO2 remains intact in the matrix, which mainly ploughs the friction surface of C/C-SiC composites in the form of hard micro bumps. SiO2 is easily embedded in the friction film of C/C-SiC composites after breaking and falling off at high braking speed, which is conducive to the accumulation of wear debris mainly composed of Cu and Cu compounds around it, and promotes the formation of friction transfer film on the friction surface of C/C-SiC composites to improve the friction and wear properties of the materials.
李陈鑫, 刘如铁, 林雪杨, 陈洁, 熊翔, 廖宁. SiO2与ZrO2组元对铜基摩擦材料与C/C-SiC复合材料配副摩擦磨损性能的影响[J]. 粉末冶金材料科学与工程, 2023, 28(1): 44-54.
LI Chenxin, LIU Rutie, LIN Xueyang, CHEN Jie, XIONG Xiang, LIAO Ning. Effects of SiO2 and ZrO2 on friction and wear properties of copper-based friction materials mated with C/C-SiC composites. Materials Science and Engineering of Powder Metallurgy, 2023, 28(1): 44-54.
[1] SHI L, WANG F, MA L, et al.Study of the friction and vibration characteristics of the braking disc/pad interface under dry and wet conditions[J]. Tribology International, 2018, 127: 533-544. [2] AKHTAR K, HIRA U, KHALID H, et al.Uniform fine particles of ZrO2 as reinforcement filler in the electrodeposited Cu-ZrO2 nanocomposite coating on steel substrate[J]. Journal of Alloys and Compounds, 2019, 772: 15-24. [3] MAHHEIDARY F, TOLAMINEJAD B, MOMENI A.Surface composite on Cu substrate with SiO2 reinforcement fabricated by severe plastic deformation: Microstructure, mechanical and tribological properties[J]. Journal of Alloys and Compounds, 2019, 793: 86-95. [4] 李政舟, 刘如铁, 林雪杨, 等. SiO2/ZrO2复合陶瓷组元对铜基摩擦材料摩擦磨损性能的影响[J]. 粉末冶金材料科学与工程, 2021, 26(2): 108-116. LI Zhengzhou, LIU Rutie, LIN Xueyang, et al.Effects of SiO2/ZrO2 composite ceramic components on friction and wear properties of copper-based friction materials[J]. Materials Science and Engineering of Powder Metallurgy, 2021, 26(2): 108-116. [5] 刘超, 姚萍屏, 周海滨, 等. ZrO2晶型对铜基粉末冶金摩擦材料摩擦学性能的影响[J]. 润滑与密封, 2019, 44(2): 6-13. LIU Chao, YAO Pingping, ZHOU Haibin, et al.Effect of crystal structures of ZrO2 on tribological properties of copper-based powder metallurgy friction materials[J]. Lubrication Engineering, 2019, 44(2): 6-13. [6] JIANG G, YANG J, XU Y, et al.Effect of graphitization on microstructure and tribological properties of C/SiC composites prepared by reactive melt infiltration[J]. Composites Science and Technology, 2008, 68(12): 2468-2473. [7] 徐兴亚, 张立同, 成来飞, 等. 碳陶刹车材料的研究进展[J]. 航空制造技术, 2014, 450(6): 100-103. XU Xingya, ZHANG Litong, CHENG Laifei, et al.Research progress of carbon/silicon carbide brake materials[J]. Aeronautical Manufacturing Technology, 2014, 450(6): 100-103. [8] 杨晓涛, 袭建人, 齐广慧, 等. 炭/炭-碳化硅汽车制动材料的研究[J]. 汽车工艺与材料, 2014(10): 24-26. YANG Xiaotao, XI Jianren, QI Guanghui, et al.Research on C/C-SiC automobile brake material[J]. Automobile Technology and Material, 2014(10): 24-26. [9] 张立同, 成来飞, 徐永东. 新型碳化硅陶瓷基复合材料的研究进展[J]. 航空制造技术, 2003(1): 24-32. ZHANG Litong, CHENG Laifei, XU Yongdong.Progress in research work of new CMC-SIC[J]. Aeronautical Manufacturing Technology, 2003(1): 24-32. [10] LI G, YAN Q.Comparison of Friction and Wear Behavior Between C/C, C/C-SiC and Metallic Composite Materials[J]. Tribology Letters, 2015, 60(1): 139-146. [11] STADLER Z, KRNEL K, KOSMAC T.Friction behavior of sintered metallic brake pads on a C/C-SiC composite brake disc[J]. Journal of the European Ceramic Society, 2007, 27(2/3): 1411-1417. [12] ZHAO S, YAN Q, PENG T, et al. The braking behaviors of Cu-Based powder metallurgy brake pads mated with C/C-SiC disk for high-speed train[J]. Wear, 2020, 448-449: 203237. [13] TANG H, LI P, LI Z, et al.Braking behaviours of C/C-SiC mated with iron/copper-based PM in dry, wet and salt fog conditions[J]. Ceramics International, 2022, 48(3): 3261-3273. [14] 杜鹏程, 王雅雷, 熊翔, 等. 全长纤维针刺C/C-SiC复合材料的力学与热扩散性能[J]. 矿冶工程, 2021, 41(3): 114-119. DU Pengcheng, WANG Yalei, XIONG Xiang, et al.Mechanical and thermal diffusion properties of C/C-SiC composites with full-length fiber needled preform[J]. Mining and Metallurgical Engineering, 2021, 41(3):114-119. [15] CHEN G, LI Z, XIAO P, et al.Tribological properties and thermal-stress analysis of C/C-SiC composites during braking[J]. Transactions of Nonferrous Metals Society of China, 2019, 29(1): 123-131. [16] 韩晓明, 符蓉, 高飞, 等. SiO2含量对铜基摩擦材料摩擦行为的影响[J]. 中国有色金属学报, 2009, 19(10): 1848-1853. HAN Xiaoming, FU Rong, GAO Fei, et al.Effects of content of SiO2 particles on tribological behavior of Cu-matrix friction materials[J]. The Chinese Journal of Nonferrous Metals, 2009, 19(10): 1848-1853. [17] ZHANG P, ZHANG L, WEI D, et al.The synergistic effect of Cr and CrFe particles on the braking behavior of Cu-based powder metallurgy brake pads[J]. Tribology Transactions, 2019, 62(6): 1072-1085. [18] MA X, LUAN C, FAN S, et al.Comparison of braking behaviors between iron-and copper-based powder metallurgy brake pads that used for C/C-SiC disc[J]. Tribology International, 2021, 154: 106686. [19] 赵恒阳, 林雪杨, 刘如铁, 等. 三种制动环与铜基摩擦材料配副的摩擦温度场研究[J]. 粉末冶金材料科学与工程, 2022, 27(2): 129-139. ZHAO Hengyang, LIN Xueyang, LIU Rutie, et al.Friction temperature field analysis of three brake rings paired with copper-based friction materials[J]. Materials Science and Engineering of Powder Metallurgy, 2022, 27(2): 129-139. [20] 战思琪. 铜-二硫化钼复合材料摩擦磨损性能的研究[D]. 长春: 长春工业大学, 2020. ZHAN Siqi.Study on friction and wear properties of copper-molybdenum disulfide composite[D]. Changchun: Changchun University of Technology, 2020.