Abstract：The tungsten layer on the surface of diamond was prepared using WO3, Mg, and diamond powders as the reaction system and NaCl as the diluent by the self-propagating high-temperature synthesis technology. The adiabatic temperature change was achieved by regulating the NaCl content, and its effects on the coverage radio and thickness of the tungsten layer on the diamond surface were systematically studied. The results show that the coverage radio and thickness of the tungsten layer on the diamond surface increase with the increasing adiabatic temperature. Under the condition that the mass ratio of WO3, diamond, Mg, NaCl is 1:0.53:0.34:0.13, when the adiabatic temperature reaches 3 569 K, a tungsten layer with a coverage radio of approximately 82%, a thickness of approximately 340 nm and uniform distribution can be obtained. Moreover, the unique instantaneous high-temperature-rapid cooling characteristic of self-propagating high-temperature synthesis effectively improves the stability of diamond, and therefore no obvious graphitization is observed.
赵卓聪, 刘咏, 王丽, 杨紫涵. 稀释剂含量对自蔓延高温合成金刚石表面钨层的影响[J]. 粉末冶金材料科学与工程, 2025, 30(6): 557-564.
ZHAO Zhuocong, LIU Yong, WANG Li, YANG Zihan. The influence of diluent content on the tungsten layer on the surface of self-propagating high-temperature synthetic diamond. Materials Science and Engineering of Powder Metallurgy, 2025, 30(6): 557-564.
[1] JIA J H, BAI S X, XIONG D G, et al.Effect of tungsten based coating characteristics on microstructure and thermal conductivity of diamond/Cu composites prepared by pressueless infiltration[J]. Ceramics International, 2019, 45(8): 10810-10818. [2] LEE M T, CHUNG C Y, YEN S C, et al.High thermal conductive diamond/Ag-Ti composites fabricated by low-cost cold pressing and vacuum liquid sintering techniques[J]. Diamond and Related Materials, 2014, 44: 95-99. [3] DIXIT M, SRIVASTAVA R.The effect of copper granules on interfacial bonding and properties of the copper-graphite composite prepared by flake powder metallurgy[J]. Advanced Powder Technology, 2019, 30(12): 3067-3078. [4] YUAN M Y, TAN Z Q, FAN G L, et al.Theoretical modelling for interface design and thermal conductivity prediction in diamond/Cu composites[J]. Diamond and Related Materials, 2018, 81: 38-44. [5] SANG J Q, YANG W L, ZHU J J, et al.Regulating interface adhesion and enhancing thermal conductivity of diamond/copper composites by ion beam bombardment and following surface metallization pretreatment[J]. Journal of Alloys and Compounds, 2018, 740: 1060-1066. [6] 刘树宇, 彭英博, 高沛然, 等. 冷喷涂铜基金刚石复合涂层的结构与性能[J]. 粉末冶金材料科学与工程, 2022, 27(6): 638-647. LIU Shuyu, PENG Yingbo, GAO Peiran, et al.Microstructure and properties of cold sprayed copper- diamond composite coatings[J]. Materials Science and Engineering of Powder Metallurgy, 2022, 27(6): 638-647. [7] WEI C L, WANG X X, WEN J, et al.Interface improvement of diamond/copper composites through a low-temperature high-efficiency coating method[J]. Thin Solid Films, 2024, 804: 140486. [8] WANG L H, BAI G Z, LI N, et al.Unveiling interfacial structure and improving thermal conductivity of Cu/diamond composites reinforced with Zr-coated diamond particles[J]. Vacuum, 2022, 202: 111133. [9] WANG L H, LI J W, CHE Z F, et al.Combining Cr pre-coating and Cr alloying to improve the thermal conductivity of diamond particles reinforced Cu matrix composites[J]. Journal of Alloys and Compounds, 2018, 749: 1098-1105. [10] GALASHOV E N, YUSUF A A, MANDRIK E M, et al.Preparation and thermo-physical parameters of diamond/W, Cu heat-conducting composite substrates[J]. The International Journal of Advanced Manufacturing Technology, 2016, 86(1): 475-478. [11] WEI C L, CHENG J G, LI J F, et al.Tungsten-coated diamond powders prepared by microwave-heating salt-bath plating[J]. Powder Technology, 2018, 338: 274-279. [12] ABYZOV A M, KIDALOV S V, SHAKHOV F M.High thermal conductivity composites consisting of diamond filler with tungsten coating and copper (silver) matrix[J]. Journal of Materials Science, 2011, 46(5): 1424-1438. [13] SANG J Q, ZHOU L P, YANG W L, et al.Enhanced thermal conductivity of copper/diamond composites by fine- regulating microstructure of interfacial tungsten buffer layer[J]. Journal of Alloys and Compounds, 2021, 856: 157440. [14] 王树义, 肖冰, 肖皓中, 等. 镍基钎料真空钎焊镀钨金刚石的研究[J]. 金刚石与磨料磨具工程, 2023, 43(2): 202-209. WANG Shuyi, XIAO Bing, XIAO Haozhong, et al.Research on vacuum brazing of W-coated diamond with Ni-based filler alloy[J]. Diamond and Abrasives Engineering, 2023, 43(2): 202-209. [15] JIA J H, BAI S X, XIONG D G, et al.Enhanced thermal conductivity in diamond/copper composites with tungsten coatings on diamond particles prepared by magnetron sputtering method[J]. Materials Chemistry and Physics, 2020, 252: 123422. [16] WANG Y Y, MA J, LI H, et al.Technical study of tungsten plating on surface of diamond powder by CVD[J]. Surface Technology, 2017, 46(2): 98-102. [17] 臧建兵, 赵玉成, 王明智, 等. 超硬材料表面镀覆技术及应用[J]. 金刚石与磨料磨具工程, 2000(3): 8-12. ZANG Jianbing, ZHAO Yucheng, WANG Mingzhi, et al.Superhard abrasives cladding technology and its application[J]. Diamond and Abrasives Engweering, 2000(3): 8-12. [18] 史冠勇, 熊民, 陈平, 等. 自蔓延高温合成制备钨粉的热力学研究[J]. 江西冶金, 2019, 39(3): 12-15. SHI Guanyong, XIONG Min, CHEN Ping, et al.A study on the thermodynamic of preparation of tungsten powder by self-propagating high temperature synthesis[J]. Jiangxi Metallurgy, 2019, 39(3): 12-15. [19] WILHELM H, LELAURAIN M, MCRAE E, et al.Raman spectroscopic studies on well-defined carbonaceous materials of strong two-dimensional character[J]. Journal of Applied Physics, 1998, 84(12): 6552-6558. [20] 朱瑞华, 刘金龙, 陈良贤, 等. 金刚石自支撑膜拉曼光谱1 420 cm-1特征峰研究[J]. 人工晶体学报, 2015, 44(4): 867-871. ZHU Ruihua, LIU Jinlong, CHEN Liangxian, et al.Research on 1 420 cm-1 characteristic peak of free-standing diamond films in Raman spectrum[J]. Journal of Synthetic Crystals, 2015, 44(4): 867-871. [21] SHIRIEV A A, MUKASYAN A S.Thermodynamics of SHS processes[J]. Concise Encyclopedia of Self-Propagating High-Temperature Synthesis, 2017: 385-387. [22] 叶大伦. 实用无机物热力学数据手册[M]. 北京: 冶金工业出版社, 1981: 1032-1056. YE Dalun.Practical Inorganic Thermodynamic Data Manual[M]. Beijing: Metallurgical Industry Press, 1981: 1032-1056. [23] 丁晟, 王海龙, 马莉, 等. 等离子体渗硼对硬质合金表面金刚石涂层的影响[J]. 粉末冶金材料科学与工程, 2024, 29(3): 181-190. DING Sheng, WANG Hailong, MA Li, et al.Effect of plasma boriding on diamond coating of cemented carbide surface[J]. Materials Science and Engineering of Powder Metallurgy, 2024, 29(3): 181-190. [24] 高雨阳, 刘咏, 陈刚, 等. 自蔓延高温合成WC粉末的结晶行为[J]. 粉末冶金材料科学与工程, 2022, 27(6): 630-637. GAO Yuyang, LIU Yong, CHEN Gang, et al.Crystallization behavior ofself-propagating high temperature synthesis WC powder[J]. Materials Science and Engineering of Powder Metallurgy, 2022, 27(6): 630-637.
2025, Vol. 30 
